Remote-processing RPC-2350 Instrukcja Użytkownika Pobierz pdf (Strona 10)

SETUP AND OPERATION CHAPTER 2

2-4

Figure 2-2 Power connector detail

Figure 2-3 Power and jumper location detail

Ground is connected to “GND”

“+ 5V” can be pow er input or output. When W 8 is

installed on the RPC-2350G, it is power output. When

W8 is not installed, it is power input. See Chapter 16 for

more information.

“SWP WR” is a high current switch to ground. See

Chapter 6, High current output at P2 for more

information.

2. Connect one end of the VTC-9 connector to the 10

pin COM1 (programm ing) port on the RPC-2350.

Refer to Figure 2-1 for connector location.

Connect the VTC-9 serial cable to the PC' s COM1

or COM2 port .

3. Start your terminal program (if not running

already).

4. Turn on your power supply. On pow er up a

CAMBASIC (tm) V1.4

If a nonsense message appears, your terminal or PC

may not be set to the appropriate communication

parameters. If the system still does not respond,

refer to "TROU BLESH OOT ING" later in this

chapter.

4. The system is now in the " imme diate mod e" and is

ready for you to start programming. T ype the

following program (in upper or lower case:

10 FOR X = 0 TO 2

20 PRINT " Hello ";

30 NEXT

40 PRINT

Now type RUN

The system will display:

Hello Hello Hello

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 82 83

Brak uwag

Remote-processing RPC-2350 Instrukcja Użytkownika Strona 10